NNX-S216 21X9 ET 33 P.C.D 5X114.3 center hole 67.1 2piece forged wheel (custom 18-24inch any date)
What is the processing process of cake forging? Cake satin forging is also called short-axis forging. The processing process can be divided into three types according to its difficulty. Ordinary forged, high hub deep hole forging and high-gluten thin-walled complex forging. The processing process is generally rough, vertical and rough to remove gasification, and finally forged. Let’s take a look at the relevant introduction in this regard.
1. Processing process of ordinary cake forging:
Such forgeds, such as gears, flanges, shafts, etc., are relatively simple. Remove the oxide skin on the cylindrical surface of the cylindrical cylindrical surface, then flip the blank 90 degrees and light up to remove the end surface to remove the end surface. After the rough rough diameter, the diameter of the roughness should exceed the wheel spoke, reaching the middle of the wheel, so that it will not fold and make the wheels full. The cake forging is large in diameter. If you cannot set up a queue table on a forging pestle, you can use two forging hammer to jointly forged. One hammer is thick, and the other hammer is forged. Under the premise of not affecting the fullness of forging, the thick diameter should be as close to the final forging as much as possible so that the rough positioning is accurate and avoid folding.
2. Machining process of high-wheel hub deep-hole cake forged;
In the process of processing such forging parts, in order to facilitate the positioning of the rough forging neck and the filling of the wheels, the rough steps were added, the concave holes were forged in advance, and the final forging was turned over 180°.
3. Machining process of non-gluten thin-walled cake forged;
In order to ensure full or avoid folding, such forging parts need to improve metal flow conditions, and pre-forging steps are adopted. For ring-shaped parts with a large diameter, if there is no pre-forging, folding may occur. After pre-forging, the formation conditions have been improved. But sometimes a forging hammer cannot be arranged, and two forging hammer is needed.
What do you need to pay attention to during the large forging process? Heavy forgeds refer to large metals being suppressed and forming to achieve their own goals. This force is usually achieved by hammer or pressure. The forging process has established a fine grain structure to improve the physical properties of metal. In the actual use of parts, a correct design can flow the particles in the direction of the main pressure.